Computer System Organization (CS-4002)
rgpv bhopal, diploma, rgpv syllabus, rgpv time table, how to get transcript from rgpv, rgpvonline,rgpv question paper, rgpv online question paper, rgpv admit card, rgpv papers, rgpv scheme
RGPV notes CBGS Bachelor of engineering
Objectives:
Students to be familiarize the basic principles of computer architecture, Design and Multi Processing, Types of data transfer, Concept of semi conductor memories which is useful for research work in field Computer System
Syllabus
UNIT 1:
Basic Structure of Computer:
Structure of Desktop Computers, CPU: General Register Organization- Memory Register, Instruction
Register, Control Word, Stack Organization, Instruction Format, ALU, I/O System,bus,CPU and Memory
Program Counter, Bus Structure, Register Transfer Language- Bus and Memory Transfer, addressing
modes.
UNIT 2:
Control Unit Organization:
Basic Concept of Instruction, Instruction Types, Micro Instruction Formats, Fetch and Execution cycle,
Hardwired control unit, Micro-programmed Control unit- microprogram sequencer Control Memory,
Sequencing and Execution of Micro Instruction.
Computer Arithmetic:
Addition and Subtraction, Tools Compliment Representation, Signed Addition and Subtraction,
Multiplication and division, Booths Algorithm, Division Operation, Floating Point Arithmetic
Operation.design of Arithmetic unit
UNIT 3:
I/O Organization:
I/O Interface – PCI Bus, SCSI Bus, USB, Data Transfer: Serial, Parallel, Synchronous, Asynchronous
Modes of Data Transfer, Direct Memory Access(DMA), I/O Processor.
UNIT 4:
I/O Organization:
I/O Interface – PCI Bus, SCSI Bus, USB, Data Transfer: Serial, Parallel, Synchronous, Asynchronous
Modes of Data Transfer, Direct Memory Access(DMA), I/O Processor.
UNIT 5:
Multiprocessors:
Characteristics of Multiprocessor, Structure of Multiprocessor- Inter-processor Arbitration, InterProcessor Communication and Synchronization. Memory in Multiprocessor System, Concept of
Pipelining, Vector Processing, Array Processing, RISC And CISC,Study of Multicore Processor – Intel,
AMD.
NOTES
- Unit 1
- Unit 2
- Unit 3
- Unit 4
- Unit 5
- Unit 6
Reference Books:
1. Morris Mano , “Computer System Organization ” PHI
2. Alan Clements: “Computer Organization and Architecture”, Cengage Learning
3. Subrata Ghosal: “Computer Architecture and Organization”, Pearson
4. William stalling ,“Computer Architecture and Organization” PHI
5. M. Usha, T.S. Shrikant: “Computer System Architecture and Organization”, Willey India
6. Chaudhuri, P.Pal: “Computer Organization and Design”, PHI
7. Sarangi: “Computer Organization and Architecture”,Mc- Graw Hills
List of Practicals
1) Study of Multiplexer and Demultiplexer
2. Study of Half Adder and Subtractor
3. Study of Full Adder and Subtractor
4. WAP to add two 8 bit numbers and store the result at memory location 2000
5. WAP to multiply two 8 bit numbers stored at memory location 2000 and 2001 and stores the result at
memory location 2000 and 2001.
6) WAP to add two 16-bit numbers. Store the result at memory address starting from 2000.
7)WAP which tests if any bit is '0' in a data byte specified at an address 2000. If it is so, 00 would be
stored at address 2001 and if not so then FF should be stored at the same address.
8) Assume that 3 bytes of data are stored at consecutive memory addresses of the data memory starting at
2000. Write a program which loads register C with (2000), i.e. with data contained at memory address
2000, D with (2001), E with (2002) and A with (2001).
9) Sixteen bytes of data are specified at consecutive data-memory locations starting at 2000. Write a
program which increments the value of all sixteen bytes by 01.
10) WAP to add t 10 bytes stored at memory location starting from 3000. Store the result at memory
location 300A.
You May Also Like
- ES-3001 - Energy, Environment, Ecology & Society
- CS-4003 - Analog & Digital communication
- CS-4004 - Analysis & Design of algorithm
- CS-4005 - Theory of computation
- CS-4006 - Computer Programming-II [Dot Net Technology]
- CS-4006 - Computer Programming-II [Python]
- CS-4006 - Computer Programming-II [MATLAB]
- CS-4007 - Programming Tools(Internal Assessment)
- CS-4008 - Professional Ethics (Internal Assessment)
